GB/T 18457-2024
ActiveStainless steel needle tubing for the manufacture of medical devices—Requirements and test methods
制造医疗器械用不锈钢针管 要求和试验方法
Application Summary AI generated
This standard specifies the dimensions, mechanical properties, and surface quality requirements for stainless steel needle tubing used in medical device manufacturing, along with corresponding test methods. It is applied in the production and quality inspection of hypodermic needles, acupuncture needles, and other medical needle assemblies to ensure consistent performance and patient safety. The standard is relevant for medical device manufacturers, testing laboratories, and regulatory compliance in healthcare settings.
Related Standards
GB/T 19381-2003
General methods of test for medical closures of butyl rubber
GB/T 14214-2003
Spectacle frames--General requirements and test methods
GB/T 18375.7-2004
Prosthetics--Structural testing of lower-limb prostheses--Part 7:Test submission document
GB/T 18375.6-2004
Prosthetics--Structural testing of lower-limb prostheses--Part 6:Loading parameters of supplementary structural tests
GB/T 18375.5-2004
Prosthetics--Structural testing of lower-limb prostheses--Part 5:Supplementary structural tests
GB/T 18375.8-2004
Prosthetics--Structural testing of lower-limb prostheses--Part 8:Test report
GB/T 19543-2004
Prostheses--Structural testing of hip units
GB/T 19629-2005
Medical Electrical Equipment-Dosimeters with ionization chambers and/or semi-conductors as used in X-ray diagnostic imaging
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.