GB/T 18290.5-2015
ActiveSolderless connections—Part 5: Press-in connections—General requirements, test methods and practical guidance
无焊连接 第5部分：压入式连接 一般要求、试验方法和使用导则
Application Summary AI generated
This standard specifies general requirements, test methods, and practical guidance for press-in connections, which are solderless electrical connections made by pressing a contact pin into a plated through-hole of a printed circuit board. It is applied in the electronics industry for ensuring reliable, gas-tight interconnections in products like automotive electronics, telecommunications equipment, and consumer electronics, particularly where high mechanical stability and resistance to environmental stress are needed. The standard is used by manufacturers and testing laboratories to validate the performance and durability of press-fit terminations during design, production, and quality assurance.
Related Standards
GB/T 18496.2-2005
Electromechanical switches for use in electronic equipment Part 4-1:Sectional specification for lever(toggle)switches Blank detail specification
GB/T 17562.8-2002
Rectangular connectors for frequencies below 3MHz--Part 8:Detail specification for connectors，four-signal contacts and earthing contacts for cable screen
GB/T 15157.7-2002
Connectors for frequencies below 3MHz for use with printed boards--Part 7:Detail specification for connectors，8-way，including fixed and free connectors with common mating features，with assessed quality
GB/T 18501.2-2001
Connectors for use in d.c.，low-frequency analogue and digital high speed data spplications--Part 2:Circular connectors with assessed quality--Sectional specification
GB/T 18501.1-2001
Connectors with assessed quality，for use in d.c.，low frequency analogue and in digital high speed data applications--Part 1:Generic specification
GB/T 18496-2001
Electromechanical switches for use in electronic equipment--Part 4:Sectional specification for lever(toggle) switches
GB/T 17562.1-1998
Rectangular connectors for frequencies below 3 MHz--Part 1: Generic specification--General requirements and guide for the preparation of detail specifications for connectors with assessed quality
GB/T 13420-1998
Electromechanical switches for use in electronic equipment--Part 6:Sectional specification for sensitive switches--Section 1:Blank detail specification
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.