GB/T 16938-2008
ActiveFasteners - General requirements for bolts,screws,studs and nuts
紧固件 螺栓、螺钉、螺柱和螺母 通用技术条件
Application Summary AI generated
This standard specifies the general technical requirements, acceptance inspection, marking, and packaging for bolts, screws, studs, and nuts. It is applied in the manufacturing and quality control of mechanical fasteners across industries such as automotive, construction machinery, and general engineering. The standard ensures dimensional consistency, mechanical performance, and interchangeability of threaded fasteners used in assembly and structural applications.
Related Standards
GB/T 9074.5-2004
Cross recessed small pan head screw andwasher assemblies with plain washers
GB/T 62.3-2004
Wing nuts--Pressing wing
GB/T 62.1-2004
Wing nuts--Round wing
GB/T 62.2-2004
Wing nuts--Square wing
GB/T 9074.20-2004
Cross recessed hexagon head tapping screw with indentation and washer assemblies with plain washers
GB/T 62.4-2004
Wing nuts--Die-casting wing
GB/T 3098.20-2004
Mechanical properties of fasteners--Wing nuts with specified proof torque
GB/T 3098.19-2004
Mechanical properties of fasteners--Blind rivets with break pull mandrel
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.