GB/T 16927.3-2010
ActiveHigh-voltage test techniques - Part3: Definitions and requirements for on-site testing
高电压试验技术 第3部分: 现场试验的定义及要求
Application Summary AI generated
This standard defines terminology and specifies requirements for conducting high-voltage tests on electrical equipment outside of a laboratory, specifically at installation or operational sites. It is applied by engineers and technicians performing on-site dielectric tests on power transformers, switchgear, cables, and other high-voltage apparatus to verify insulation integrity after transport, installation, or maintenance. The standard ensures consistent test procedures and safety measures for field testing, where environmental conditions and test setups differ from controlled lab environments.
Related Standards
GB/T 19663-2005
Terms for Lightning Protection of Information system
GB/Z 14429-2005
Telecontrol equipmet and systems Part1:General considerations Section3:Glossary
GB/Z 25320.1-2010
Power systems management and associated information exchange - Data and communications security - Part 1: Communication network and system security -Introduction to security issues
GB/Z 25320.3-2010
Power systems management and associated information exchange - Data and communications security - Part 3: Communication network and system security -Profiles including TCP/IP
GB/Z 25320.4-2010
Power systems management and associated information exchange - Data and communications security - Part 4: Profiles including MMS
GB/Z 25320.6-2011
Power systems management and associated information exchange - Data and communications security - Part 6: Security for IEC 61850
GB/Z 25320.5-2013
Power systems management and associated information exchange - Data and communications security - Part 5: Security for GB/T 18657 and derivatives
GB/Z 25320.2-2013
Power systems management and associated information exchange - Data and communications security - Part 2: Glossary of terms
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.