GB/T 16545-2015
AbolishedCorrosion of metals and alloys—Removal of corrosion products from corrosion test specimens
金属和合金的腐蚀 腐蚀试样上腐蚀产物的清除
Application Summary AI generated
This standard specifies procedures for the chemical, electrolytic, and mechanical removal of corrosion products from metal and alloy test specimens without removing underlying base metal. It is applied in corrosion testing laboratories and quality control settings to ensure accurate mass loss measurements and surface evaluation after exposure to corrosive environments. The standard is critical for industries such as automotive, aerospace, and infrastructure, where consistent corrosion assessment is needed for material selection and durability validation.
Related Standards
GB/T 19292.1-2003
Corrosion of metals and alloys--Corrosivity of atmospheres--Classification
GB/T 19292.2-2003
Corrosion of metals andalloys--Corrosivity of atmospheres--Guiding values for the corrosivity categories
GB/T 19292.4-2003
Corrosion of metals and alloys--Corrosivity of atmospheres--Determination of corrosion rate of standard specimens for the evaluation of corrosivity
GB/T 19291-2003
Corrosion of metals and alloys--General principles for corrosion testing
GB/T 19292.3-2003
Corrosion of metals and alloys--Corrosivity of atmospheres--Measurement of pollution
GB/T 19746-2005
Corrosion of metals and alloys-Alternate immersion test in salt solution
GB/T 19745-2005
Corrosion tests in artificial atmosphere at very low Concentrations of polluting gas(es)
GB/T 19747-2005
Corrosion of metals and alloys-Determination of bimetallic Corrosion in outdoor exposure corrosion tests
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.