GB/T 15972.47-2008
AbolishedSpecifications for optical fibre test methods - Part 47: Measurement methods and test procedures for transmission and optical characteristics - Macrobending loss
光纤试验方法规范 第47部分：传输特性和光学特性的测量方法和试验程序 宏弯损耗
Application Summary AI generated
This standard specifies the test method for measuring macrobending loss in optical fibers, which quantifies the signal attenuation caused by tight bends in the fiber. It is applied in the telecommunications industry for quality control and performance verification of single-mode and multimode optical fibers used in cables, connectors, and network installations. Manufacturers and testing laboratories use this standard to ensure fiber reliability in real-world deployment scenarios where bending occurs, such as in patch panels or fiber-to-the-home (FTTH) installations.
Related Standards
GB/T 18311.5-2003
Fibre optic interconnecting devices and passive components--Basic test and measurement procedures--Part 3-5:Examinations and measurements--Wavelength dependence of attenuation
GB/T 18311.4-2003
Fibre optic interconnecting devices and passive components--Basic test and measurement procedures--Part 3-4:Examinations and measurements--Attenuation
GB/T 18311.40-2003
Fibre optic interconnecting devices and passivecomponents--Basic test and measurement procedures--Part 3-40:Examinations and measurements--Extinction ratio of a polarization maintaining(pm)fibre pigtailed connector
GB/T 18311.34-2003
Fibre optic interconnecting devices and passive components--Basic test and measurement procedures--Part 3-34:Examinations and measurements--Attenuation of random mated connectors
GB/T 7424.4-2003
Optical fiber cables--Part 4-1:Section specification--Optical fibre composite overhead ground wire
GB/T 18310.11-2003
Fibre optic interconnecting devices and passive components--Basic test andmeasurement procedures--Part 2-11:Tests--Axial compression
GB/T 18310.10-2003
Fibre optic interconnecting devices and passive components--Basic test and measurement procedures--Part 2-10:Tests--Crush resistance
GB/T 18310.26-2003
Fibre optic interconnecting devices and passive components--Basic test and measurement procedures--Part 2-26:Tests--Salt mist
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.