GB/T 15972.45-2008
AbolishedSpecifications for optical fibre test methods - Part 45: Measurement methods and test procedures for transmission and optical characteristics - Mode field diameter
光纤试验方法规范 第45部分：传输特性和光学特性的测量方法和试验程序 模场直径
Application Summary AI generated
This standard specifies the measurement methods and test procedures for determining the mode field diameter (MFD) of single-mode optical fibres. It is applied in the telecommunications industry for quality control, product certification, and performance verification of optical fibres used in long-haul and metropolitan area networks. The standard ensures accurate characterization of fibre transmission properties, which is critical for predicting splice loss, bending loss, and overall system performance.
Related Standards
GB/T 18311.40-2003
Fibre optic interconnecting devices and passivecomponents--Basic test and measurement procedures--Part 3-40:Examinations and measurements--Extinction ratio of a polarization maintaining(pm)fibre pigtailed connector
GB/T 18311.4-2003
Fibre optic interconnecting devices and passive components--Basic test and measurement procedures--Part 3-4:Examinations and measurements--Attenuation
GB/T 18311.34-2003
Fibre optic interconnecting devices and passive components--Basic test and measurement procedures--Part 3-34:Examinations and measurements--Attenuation of random mated connectors
GB/T 18311.5-2003
Fibre optic interconnecting devices and passive components--Basic test and measurement procedures--Part 3-5:Examinations and measurements--Wavelength dependence of attenuation
GB/T 7424.4-2003
Optical fiber cables--Part 4-1:Section specification--Optical fibre composite overhead ground wire
GB/T 18310.11-2003
Fibre optic interconnecting devices and passive components--Basic test andmeasurement procedures--Part 2-11:Tests--Axial compression
GB/T 18310.10-2003
Fibre optic interconnecting devices and passive components--Basic test and measurement procedures--Part 2-10:Tests--Crush resistance
GB/T 18311.1-2003
Fibre optic interconnecting devices and passive components--Basic test and measurement procedures--Part 3-1:Examinations and measurements--Visual examination
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.