GB/T 15972.34-2008
AbolishedSpecifications for optical fibre test methods - Part 34: Measurement methods and test procedures for mechanical characteristics - Fibre curl
光纤试验方法规范 第34部分：机械性能的测量方法和试验程序 光纤翘曲
Application Summary AI generated
This standard specifies the test method for measuring the curl (residual curvature) of optical fibres, which is critical for ensuring proper alignment and low splice loss in fibre optic cables. It is applied in the manufacturing and quality control of single-mode and multimode optical fibres used in telecommunications networks and data centers. The procedure is used by fibre producers, cable manufacturers, and testing laboratories to verify mechanical performance during product development and incoming inspection.
Related Standards
GB/T 18311.34-2003
Fibre optic interconnecting devices and passive components--Basic test and measurement procedures--Part 3-34:Examinations and measurements--Attenuation of random mated connectors
GB/T 18311.4-2003
Fibre optic interconnecting devices and passive components--Basic test and measurement procedures--Part 3-4:Examinations and measurements--Attenuation
GB/T 18311.5-2003
Fibre optic interconnecting devices and passive components--Basic test and measurement procedures--Part 3-5:Examinations and measurements--Wavelength dependence of attenuation
GB/T 18311.40-2003
Fibre optic interconnecting devices and passivecomponents--Basic test and measurement procedures--Part 3-40:Examinations and measurements--Extinction ratio of a polarization maintaining(pm)fibre pigtailed connector
GB/T 7424.4-2003
Optical fiber cables--Part 4-1:Section specification--Optical fibre composite overhead ground wire
GB/T 18311.1-2003
Fibre optic interconnecting devices and passive components--Basic test and measurement procedures--Part 3-1:Examinations and measurements--Visual examination
GB/T 7424.1-2003
Generic specification for optical fibre cables--Part 1:General
GB/T 18310.26-2003
Fibre optic interconnecting devices and passive components--Basic test and measurement procedures--Part 2-26:Tests--Salt mist
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.