GB/T 15531-1995
AbolishedBelt drives--Pulleys--Limiting values for adjustment of centres
带传动 带轮 中心距调整极限值
Application Summary AI generated
This standard specifies the permissible adjustment range for center distances in belt drive systems, ensuring proper belt tension and alignment. It is applied in the design, manufacturing, and maintenance of mechanical equipment using pulleys and belts, such as industrial machinery, automotive engines, and agricultural equipment. The standard provides limiting values to prevent belt slippage, excessive wear, or premature failure during operation.
Related Standards
JB/T 6368-2010
Classification for chain products
GB/T 4140-2003
Flat-top chains and associated chain wheels for conveyors
GB/T 13487-2002
Synchronous belts for general drive
GB/T 10715-2002
Belt drives--V-ribbed belts，joined V-belts and V-belts including wide section belts and hexagonal belts--Electrical conductivity of antistatic belts:Characteristics and methods of test
GB/T 10413-2002
Grooved pulleys for narrow V-belts(system based on effective width)
GB/T 10412-2002
Grooved pulleys for classical and narrow V-belts (system based on datum width)
GB/T 14562-1999
V-belts--Fatigue test--Loaded method
GB/T 11358-1999
Belt drives--Flat transmission belts and corresponding pulleys--Dimensions and tolerances
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.