GB/T 14598.301-2010
AbolishedGeneral specification of transformer fault oscillograph equipment for microprocessor-based generator
微机型发电机变压器故障录波装置技术要求
Application Summary AI generated
This standard specifies the technical requirements, test methods, inspection rules, and marking/packaging for microprocessor-based fault oscillograph equipment used in generator and transformer systems. It is applied in the design, manufacturing, and testing of devices that record electrical waveforms during power system faults, primarily in power plants and substations. The standard ensures accurate fault data capture for post-event analysis, aiding in grid reliability and equipment protection.
Related Standards
GB/T 19663-2005
Terms for Lightning Protection of Information system
GB/Z 14429-2005
Telecontrol equipmet and systems Part1:General considerations Section3:Glossary
GB/Z 25320.3-2010
Power systems management and associated information exchange - Data and communications security - Part 3: Communication network and system security -Profiles including TCP/IP
GB/Z 25320.1-2010
Power systems management and associated information exchange - Data and communications security - Part 1: Communication network and system security -Introduction to security issues
GB/Z 25320.4-2010
Power systems management and associated information exchange - Data and communications security - Part 4: Profiles including MMS
GB/Z 25320.6-2011
Power systems management and associated information exchange - Data and communications security - Part 6: Security for IEC 61850
GB/Z 25320.5-2013
Power systems management and associated information exchange - Data and communications security - Part 5: Security for GB/T 18657 and derivatives
GB/Z 25320.2-2013
Power systems management and associated information exchange - Data and communications security - Part 2: Glossary of terms
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.