GB/T 13829.7-2004

Active

Grooved pins--Half-length reverse-taper grooved

槽销半长倒锥槽

Standard Type

GBT

ICS

21.060.50

CCS

J13

Status

Active

Issue Date

2004-02-10

Implementation

2004-08-01

Centralized Committee

中国机械工业联合会

Issuing Authority

中国机械工业联合会

Application Summary AI generated

This standard specifies the dimensions, tolerances, and technical requirements for half-length reverse-taper grooved pins. It is applied in mechanical assemblies where a press-fit fastener is needed to secure components against axial displacement, commonly in automotive, agricultural machinery, and general industrial equipment. The pin's reverse-taper groove design provides a locking effect when driven into a drilled hole, ensuring reliable retention under vibration or dynamic loads.

Related Standards

GB/T 9074.5-2004 Cross recessed small pan head screw andwasher assemblies with plain washers GB/T 62.1-2004 Wing nuts--Round wing GB/T 62.2-2004 Wing nuts--Square wing GB/T 9074.20-2004 Cross recessed hexagon head tapping screw with indentation and washer assemblies with plain washers GB/T 62.3-2004 Wing nuts--Pressing wing GB/T 3098.20-2004 Mechanical properties of fasteners--Wing nuts with specified proof torque GB/T 62.4-2004 Wing nuts--Die-casting wing GB/T 3098.19-2004 Mechanical properties of fasteners--Blind rivets with break pull mandrel

Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.