GB/T 12859.201-2012
ActivePiezoelectric ceramic resonators - A specification in the quality assessment System for electronic components - Part 2-1: Blank detail specification-Assessment level E
电子元器件质量评定体系规范 压电陶瓷谐振器 第2-1部分：空白详细规范-评定水平E
Application Summary AI generated
This standard provides a blank detail specification for piezoelectric ceramic resonators with assessment level E, defining the specific quality and reliability requirements for these components within the electronic components quality assessment system. It is applied by manufacturers and testing laboratories in the electronics industry to ensure consistent performance, testing procedures, and qualification of ceramic resonators used in frequency control circuits, such as in oscillators and timing devices.
Related Standards
GB/T 12634-1990
Test methods for electroelastic constants of piezoelectric crystals
GB/T 12633-1990
Terms for the measurements of the properties of the piezoelectric crystals
GB/T 12275-1990
The rule of type designation for quartz crystal oscillators
GB/T 11320-1989
Test methods for the properties of piezoelectric ceramics--Material with the low mechanical quality factor
GB/T 11312-1989
Test methods for SAW properties of piezoelectric ceramics and crystals
GB/T 11311-1989
Test methods for the properties of piezoelectric ceramics--Test for Poisson’s ratio σE
GB/T 11310-1989
Test methods for the properties of piezoelectric ceramics--Test methods for temperature characteristics of relative free dielectric constants
GB/T 11309-1989
Test methods for the properties of piezoelectric ceramics--Quasi-static testfor piezoelectric strain content d33
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.