GB/T 11015-1989

Active

Interface between data terminal equipment and automatic calling equipment for data communication

数据通信用数据终端设备和自动呼叫设备之间的接口

Standard Type
GBT
ICS
33.040.50
CCS
L78
Status
Active
Issue Date
1989-03-31
Implementation
1990-01-01
Centralized Committee
工业和信息化部（通信）
Issuing Authority
工业和信息化部（通信）

Application Summary AI generated

This standard specifies the electrical, functional, and procedural interface requirements between data terminal equipment (DTE) and automatic calling equipment (ACE) for data communication networks. It is applied in China to ensure interoperability between terminals and network-based auto-dialing units, primarily in public switched telephone network (PSTN) data transmission and modem-based communication systems. The standard defines signal definitions, timing, and control sequences for automated call setup and termination in data communication applications.

Related Standards

GB/T 3382.2-2003 Technical requirements for group 3 facsimile apparatus used in public telephone network--Part 2:Procedures for document facsimile transmission in the general switched telephone network GB/T 3382.1-2003 Technical requirements for group 3 facsimile apparatus used in public telephone network--Part 1:Standardization of group 3 facsimile terminals for document transmission GB/T 19516-2004 The specifications of wired-emergency telephone system of expressway GB/Z 41298-2022 Internet of thing (IoT) application protocol—Test methods of the constrained application protocol (CoAP) GB/Z 41293-2022 Technology requirements on WAN based fast and self-deployment of sensor and actuator type of devices GB/Z 41294-2022 Internet of thing (IoT) application protocol—Technical requirements of the constrained application protocol (CoAP) GB/Z 41292-2022 General technology requirements on WAN based remote measurement and control applications for intelligent agriculture GB/T 15279-2002 The specifications of automatic telephone set
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.