GB/T 10922-2006
AbolishedGauges for pipe threads with 55 degree thread angle where pressure-tight joints are not made on the threads
55°非密封管螺纹量规
Application Summary AI generated
This standard specifies the dimensions, tolerances, and marking requirements for gauges used to inspect 55-degree non-pressure-tight pipe threads. It is applied in manufacturing and quality control to verify the thread form and fit of general-purpose pipe connections, such as those in plumbing, gas, and low-pressure fluid systems, where the seal is achieved by a gasket or other means rather than the threads themselves.
Related Standards
GB/T 9144-2003
General purpose metric screw threads--Preferable plan
GB/T 2516-2003
General purpose metric screw threads--Limit deviations
GB/T 197-2003
General purpose metric screw threads--Tolerances
GB/T 196-2003
General purpose metric screw threads--Basic dimensions
GB/T 193-2003
General purpose metric screw threads--Generalplan
GB/T 192-2003
General purpose metric screw threads--Basic profile
GB/T 1414-2003
General purpose metric screw threads--The plan for pipe systems
GB/T 9146-2003
General purpose metric screw threads--Limits of sizes for the screw threads of coarse quality and preferable plan
Transparency note: The application summary and key sentences on this page were automatically generated by AI from the standard's original text. This content has not been human-verified and should not be used for compliance or regulatory purposes. Always refer to the official standard document from the issuing authority.